EasyManuals Logo

Planet SGSW-2620 User Manual

Planet SGSW-2620
115 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #40 background imageLoading...
Page #40 background image
- 40 -
This sub-menu contains ten items:
MAC Address Ageing Time:
MAC address table refresh time setting. Input the number of seconds that an inactive MAC address
remains in the SGSW-2620s MAC address table. The available range is 0, 300~765 seconds. De-
fault mode is 300 seconds.
Broadcast Storm Filter mode:
Configure the broadcast storm filter mode. The available threshold values are 5%, 10%, 15%, 20%,
25%, and N/A. The port will be block cause of broadcast packet is over the percentage of traffic.
Max Bridge Transmit Delay Bound:
Limit the packets queuing time in switch. If enable, the packets queued exceed will be drop. Press
Space key to set the time. This valid value are 1sec, 2sec, 4sec and off. Default mode is off.
Low Queue Delay Bound:
Limit the low priority packets queuing time in switch. If enable, the low priority packet stays in switch
exceed Low Queue Max Delay Time, it will be sent. Press Space key to disable or enable this
function.
Low Queue Max Delay Time:
To set the time that low priority packets queuing on SGSW-2620. Default Max Delay Time is 255ms.
The valid range is 1~255 ms.
Collisions Retry Forever:
Disable In half duplex, if happens collision, the SGSW-2620 will retry 48 times and then drop frame.
Enable In half duplex, if happens collision, the SGSW-2620 will retry forever.
Hash Algorithm:
This Hash Algorithm is for hardware maintain on MAC table calculation. Provide CRC or Direct Map
IFG compensation: Disable or enable this function.
IP Stacking Group ID (065535):
Assign the stacking group ID. The switches must assign the same stacking group ID and can stack
together as a group.
IP Stacking Mode:
Disable or enable the stacking function. There are three stacking modes. Any port on the switch can
be used to stack. To configure the switch in stacking group, please use the Web interface of
SGSW-2620
Disable: The stack function is not working.
Master:
There must have a leader switch to control all other switches in stacking group. You can only assign
one switch to be the master switch in one stacking group. When the stacking group is set up, the
master switch will control all switches in the stacking group.
Slave:
Besides the master switch, rest of the switches are called slave switch in stacking group. When the
stacking group is set up, only can configure the slave switches through the master switch.
After setup completed, press ESC and choose Save to save the current configuration.
4.4.2.9 Main Menu
Return to the main menu screen.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Planet SGSW-2620 and is the answer not in the manual?

Planet SGSW-2620 Specifications

General IconGeneral
BrandPlanet
ModelSGSW-2620
CategoryNetwork Router
LanguageEnglish

Related product manuals