- 49 -
Figure 4-70 SNMP Trap managers save successfully screen
Press any key for return to previous menu.
Edit Trap Managers procedure:
1.Press “Edit”.
2.Choose the Community Name that want to edit and press “Enter”.
3.Press “Edit” to edit the existence IP address and Community Name.
4.After setup completed, press “ESC” and choose “Save” to save the current configuration.
Delete Trap Managers procedure:
1.Press “Delete”.
2.Choose the Community Name that want to edit and press “Enter”.
4.4.3.2.4 Previous Menu
Return to Protocol Related Configuration screen.
4.4.3.3 LACP Configuration
The Link Aggregation Control Protocol (LACP) provides a standardized means for exchanging infor-
mation between Partner Systems on a link to allow their Link Aggregation Control instances to reach
agreement on the identity of the Link Aggregation Group to which the link belongs, move the link to that
Link Aggregation Group, and enable its transmission and reception functions in an orderly manner.
Link aggregation lets you group up to eight consecutive ports into a single dedicated connection. This
feature can expand bandwidth to a device on the network. LACP operation requires full-duplex
mode, please refer to IEEE 802.3ad for detail information. The LACP Configuration screen in Figure
4-71 appears.
To Next Page
Loading...
Need help?
General
