Planet SGSW-2620 - Page 78

- 78 -
5.4.5.1 Aggregator Setting
Table 5-6 descriptions the Aggregator Setting objects of switch. The screen in Figure 5-16 appears.
Table 5-6 Descriptions of the SGSW-2620 Switch Aggregator Setting Web Page screen Objects
Please click” Help” button; the following screen in Figure 5-17 appears.
Figure 5-17 SGSW-2620 Aggregator Setting help Web Page screen
Click “Close” to close this screen.
OObject
Description
System Priority
A value used to identify the active LACP. The Switch with lowest value has the highest
priority and is selected as the active LACP.
Group ID
After creating a new link aggregation across two or more ports, choose the “Group ID”
and
click “Select”.
LACP
If enable LACP, the trunk group is LACP static trunking group. If disable LACP, then the
trunk
group is local static trunking group. All port support LACP dynamic trunking group, if con-
necting the device that also supports LACP, the
LACP dynamic trunking group will be create
automatically.
Work Ports
The max number of ports can be aggregate at the same time. Under LACP static trunking
mode, if one of port fail, the exceed ports is standby and able to aggregate. Under local
static trunking group, the member must be the same as group ports.
Add
Select
the ports to join the trunking group. If enable LACP, you can configure LACP Active/
Passive status in each ports. Click “Apply” to take effect.
Remove Select the ports to remove the trunking group. Click “Apply” to take effect.
Delete To delete trunk group. Click “Delete” to take effect.