CONTROL PANEL
16 Planmeca ProX
User’s Manual
8.2.5 Parameter adjustment keys
Press the SELECT key briefly to select the parameter - kV,
mA, exposure time or density - to be changed. When the
parameter value is flashing on the display, the parameter
can be changed with the parameter adjustment keys. The
up key increases the value and the down key decreases it.
After adjusting the kV or mA value or exposure time the
unit will return automatically to the time adjustment mode
after 5 seconds time.
8.2.6 Ready indicator light
The green ready indicator light will come on when the unit
is ready to take an exposure. The waiting time between
exposures is 12 times exposure time, but always at least 6
seconds.
In the programming mode the ready light will start to flash.
NOTE Planmeca Prox with Dixi3 or Planmeca ProSensor
system:
You can set the unit so that the Ready indicator light
will only come on when the Romexis / Dimaxis
program is ready for the exposure, i.e. the message
Waiting for exposure appears on the computer
screen. To change the settings of the unit contact
your Planmeca technical support.
8.2.7 Exposure key
When you take an exposure you must press and hold
down the exposure key for the entire duration of the
exposure.
8.2.8 Exposure warning indicator light
The yellow exposure warning light will come on when you
take an exposure. You will also hear an audible warning
sound during the exposure.
To Next Page
Loading...
Need help?
General
