Plustek PS188 - Scanner Utility

MacAction Help4
All rights are reserved.
the pop-up menu that opens.
4.
Click on the
Start
button to begin the calibration process.
5.
The scanner pulls the calibration sheet through the scanner, which completes
this scanner calibration. After the calibration is complete, click
OK
.
1.3
Scanner Utility
To save power consumption, the scanner will enter the standby mode after it is
idle for a while.
You may
disable the standby mode
or define an idle time for the
scanner
to automatically
enter the standby mode
.
1.
Right-click the icon
in the Dock, and then choose
Scanner Utility
in
the pop-up menu that opens
2.
In the
Standby Mode
section of the Scanner Utility window that opens,
click the button of your option:
a.
To disable the Standby Mode
: Click the button before
Disable Standby
Mode
.
b.
To automatically
enter the Standby Mode (
Sleep
)
: Click the button
before
Sleep
and then click the up or down arrows to
set a default time
for the
scanner
to automatically
enter the Standby Mode
.
c.
To automatically
enter the Standby Mode (
Hibernate
)
: Click the button
before
Hibernate
and then click the up or down arrows to
set a default
time for the
scanner
to automatically
enter the Standby Mode
.
(This
function may or may not be available depending on the scanner model
you purchase.)
3.
Click on
OK
button to save settings and exit.
·
To completely shut down the scanner, press the
power switch
on the rear
of the scanner
.
·
If the scanner will not be used for a long period of time, shut down the
scanner and then disconnect the power cable from the power outlet
.