OPERATION MANUAL TMS4000
TMS4000 Operation Manual 2018-08-03.docx August 3, 2018
PAGE 42
Selecting a Test Frequency of MONTHLY creates a repeating test that will run once a month at the
configured start time and date displayed.
Selecting the radio button for On The nth Date Of The Month allows the user to run the test on that
data every month. Do not select a date higher than 28 to avoid skipping a test in February.
Selecting the radio button On nth Day of Week allows the test to be run once a month on a specific
day of the week. The example above show the setting as On First Sunday which would cause the
TMS to begin the test on First Sunday of the month at the designated time.
Controls are provided for selecting the Start Time and Test Length. If the test requires a minimum %
Volume, be sure to check the box to establish that requirement. The test will NOT run if the percent
volume is below this threshold. The percentage value is configured in the Setup/Config/Tanks/Leak
Test menu (See Section 2.8).
To Next Page
Loading...