OPERATION MANUAL TMS4000
TMS4000 Operation Manual 2018-08-03.docx August 3, 2018
PAGE 65
Dialing Type: Choice between tone (pushbutton) and pulse (rotary) dialing.
Modem Type: Choices are as follows:
• None: No Modem or Serial C expansion card installed
• Internal: Supports 900433-x Internal Data Modem
• Fax Modem: Supports 900503-1 Internal Fax Modem
• Port Modem: Intended for external modem connected to the RS-232 port. Contact
Pneumercator for specific devices supported.
• Serial C: Supports the 900571-x Communications Expansion Cards
• Cell Modem: Intended for a cellular modem. Contact Pneumercator for specific devices
supported.
Port Speed: determines the maximum speed the modem is permitted to communicate at.
Pause length: defines the duration of the pause represented by a comma in the dial out string. See
Section 2.15 for entering phone number and comma in configuration.
Telephone Line Mode:
• Dedicated: allows the TMS try placing a call without detecting a dial tone. After 5 unsuccessful
attempts, the TMS will no longer attempt to place a call for this particular event.
• Shared: the TMS must detect a dial tone before attempting to place a call. After 5 unsuccessful
attempts, the TMS will no longer attempt to place a call for this particular event. Failure to
detect a dial tone does NOT qualify as a failed attempt.
Security Enable: Requires a 6-digit numeric Access Code that is prepended to any command issued
to the TMS.
To Next Page
Loading...