5.3
BODY / STEERING / SUSPENSION
5
CAB FRAME
Assembly / Removal
NOTE: Finger tighten all components until cab frame is completely assembled on vehicle, then tighten to
specifications listed.
1. Assemble the rear cab frame and the front cab frame at the coupler joints and secure with four (3/8-16 x 1 1/4) screws and
(3/8-16 Nyloc) nuts. Tighten screws to 25-28 ft. lbs. (34-38 Nm).
2. Place the assembled cab frame onto the vehicle and align the rear mount holes. Fasten the rear cab frame brackets to vehicle
with four (5/16-18) bolts and (5/16-18) nuts. Tighten bolts to 16-18 ft. lbs. (22-24 Nm). Fasten the two tap screws to the rear
inner portion of the bracket on each side. Tighten tap screws to 15 ft. lbs. (20 Nm).
3. Fasten the front of the cab frame to the base brackets and secure with four (3/8-16 x 1 1/4) screws and (3/8-16 Nyloc) nuts.
Tighten screws to 25-28 ft. lbs. (34-38 Nm).
4. Attach the cab frame to the side bars mounted on vehicle. Tighten screws to 8-9 ft. lbs. (11-12 Nm).
5. To remove the cab frame, reverse the assembly procedure (steps 1-4).
To Next Page
Loading...
Need help?
General
