TRANSMISSION
8.19
23. Install center shaft assembly.
24. Install Low shift fork with sliding dog in place.
Dogs must be positioned outward (toward you).
Slide the shift dog over the spline and the low
range shift shaft.
25. Lubricate and install inner thrust washer, low
gear, and needle bearing.
26. Install outer thrust washer and bearing.
27. Install plastic oil deflector. Apply Loctitet 242
(PN 2871949) to screw threads. Be sure
deflector pin seats into case.
28. Do not over-tighten deflector screws, or deflector
may crack.
29. Install drive gear with chain.
30. Install chain tensioner. Refer to Illustration on
following page.
Enfocus Software - Customer Support
To Next Page
Loading...
