3
9931493 R03 - 2020-2021 Sportsman XP 1000 S Service Manual
© Copyright Polaris Inc.
3.75
CAMSHAFT / CAMSHAFT CARRIER
INSTALLATION
1. Loosen all valve adjuster lock nuts.
2. Turn adjuster screws out (counterclockwise) until
they lightly seat against rocker arm.
IMPORTANT
DO NOT force screws against rocker arm. The adjuster
pivot ball may be damaged if forced.
3. Using a 12mm Allen socket, rotate the flywheel
clockwise (direction of engine rotation) until Top
Dead Center mark
w
on flywheel is aligned with
crankcase parting line
e
. This is TDC for MAG side
cylinder.
4. Rotate camshaft until pin
r
is at 10:00 position
t
.
5. Install camshaft carrier and install all carrier bolts
snug. Torque in two steps following sequence
shown.
TORQUE
Camshaft Carrier Bolts (M8)
12 ft-lb (17 Nm)
ENGINE / COOLING SYSTEM
To Next Page
Loading...
