Polaris Sportsman XP 1000 S 2020 - Rear Cab; Rear Cab Removal; Installation; License Plate Bracket (International Models); License Plate Bracket Removal; Installation

11.20
9931493 R03 - 2020-2021 Sportsman XP 1000 S Service Manual
© Copyright Polaris Inc.
REAR CAB
REAR CAB REMOVAL / INSTALLATION
1. Remove the seat.
2. Remove the (2) push rivets
q
retaining the rear cab.
3. Remove the (3) push rivets
w
retaining the rear
fender flare to the rear cab and the (1) push rivet
retaining the footwell to the rear cab. Repeat on other
side.
NOTICE
LH side shown.
4. Remove the rear cab with the rear rack and rear
fender flares attached.
5. Reverse this procedure to reinstall the rear cab.
LICENSE PLATE BRACKET
(INTERNATIONAL MODELS)
LICENSE PLATE BRACKET REMOVAL /
INSTALLATION
1. Disconnect the license plate light electrical connector
q
from the main electrical harness
w
.
2. Remove the four license plate bracket bolts
e
and
nuts
r
from the chassis.
3. Remove the license plate bracket and license plate
light from the vehicle.
4. Reverse this procedure to reinstall the license plate
bracket and license plate light. Torque fasteners to
specification.
TORQUE
License Plate Bracket Fasteners
8 ft-lbs (11 N·m)
BODY / FRAME