12
9931493 R03 - 2020-2021 Sportsman XP 1000 S Service Manual
© Copyright Polaris Inc.
12.11
Move the switch to HIGH. There should be continuity
between pins YE and YE/DG.
GEAR SELECTOR RESISTOR MODULE
The resistor module relays a different resistance reading
to the ECM depending on which gear is selected by the
operator. If the module fails, the ECM will not be able to
determine what gear the transmission is in.
1. Disconnect the ECM harness connector from the
ECM. Locate pins 23 (WHITE) and 30 (VIOLET).
2. Set the multimeter to register OHMS (resistance).
Insert the RED probe into pin 23 and the BLACK
probe into pin 30.
3. Reference the Resistance Table for specifications. If
any of the tests fail, replace the resistor module.
MODULE RESISTANCE ±5%
GEAR POSITION
RESISTANCE (Ω)
HIGH 620
LOW 300
NEUTRAL 160
REVERSE
75
PARK 24
TRANSMISSION (GEAR POSITION)
SWITCH
The transmission switch is located on the right side of the
transmission. The switch can be accessed through the
right rear wheel well opening.
1. Disconnect the transmission switch harness by lifting
the connector lock and pulling on the 2-pin connector.
Do not pull on the wiring.
2. Test transmission switch for continuity in each gear
position and compare to the specifications below.
BODY ELECTRICAL
To Next Page
Loading...
