Engine / Cooling
3.35
Engine Disassembly
25. Remove crankcase bolts.
26. Turn crankcase over. Using a soft--faced hammer,
separate the upper half from lower.
27. Photo depicts crankshaft assembly parts. Discard
seals, O--ring, and bearing retainer clip.
NOTE: Some engines will be manufactured with crank-
shafts that feature a center guide snap ring. Always verify
during disassembly the use of a snap ring or not. New
crankshafts used as service parts will have a snap ring
installed. Simply remove the snap ring from the crankshaft
if the engine you are servicing does not have this feature.
To Next Page
Loading...