Fuel Injection System
8.30
Session Completion / Code Clearing
The Session Completion screen is displayed after you
have seen the last Service Code screen. The Session
Completion screen provides three options:
1. If you type 1, the computer will display a message
asking if you are sure you want to clear the codes.
Press ESCAPE if you do not want to clear the
Service Codes. Pressing any other key will clear
the codes. A screen will then appear telling you the
service codes were successfully cleared.
2. If you type 2, the computer will display the Service
Code Review screen, then page through the Code
screens again.
3. You can end the session and return to the Main
Menu without clearing the Service Codes by typing
ESC.
FFIt Diagnostics -- Static Tests
The Illustration to the right shows the Static Test
screen. You get to this screen by pressing 2 at the Main
Menu. It allows you to select and test one of three en-
gine functions.
NOTE: Before selecting a static test, make sure the
engine is not running.
SESSION COMPLETION
Select 1, 2 or X:
Please choose one of the following options to
complete this diagnostics session before test-
ing engine.
1 - Clear all service codes
2 - Review current service codes
without clearing codes
X - End session return to Menu with-
out clearing service codes.
DO YOU REALLY WANT TO CLEAR
SERVICE CODES?
PRESS (ESC) TO CANCEL
OR PRESS ANY OTHER KEY TO CLEAR CODES
STATIC TESTING MENU
SELECT 1 THRU 3 OR X:
1) TEST FUEL INJECTORS
2) TEST IGNITION FIRING
3) TEST FUEL PUMP
X) EXIT STATIC TESTING
To Next Page
Loading...