4 - 23
Figure 4-27. Removal of Front Shutter Housing
Figure 4-28. Discharging Strobe Capacitor
e. Using a square drive, remove the screw that secures Solenoid # 2 to the Lens Mounting Plate.
Gently lift off Solenoid # 2 being careful not to catch on the locating pin of the Far Focus Lens.
f. Using a solder aid tool, gently pry open the locking tabs that secures the front Lens to the Lens
Mounting Plate. Remove the Front Lens.
h. Using a narrow blade flat screwdriver, gently release the locking tabs (Figure 4-30) that secures
the PC Board and Lens Mounting Plate to the Base Block Assembly.
i. Once the locking tabs are released, turn over the Assembly (approximately 180
0
) so that the
Base Block Assembly faces down. Gently lift off the PC Board and Lens Mounting Assembly.
FRONT SHUTTER
HOUSING
BASE BLOCK
ASSEMBLY
DUMP
PROBE
STROBE
CAPACITOR
CONTACTS
To Next Page
Loading...
