Pair Your Remote Control
Out of the box, your remote control is paired with the G7500 system, so no setup is required. To use a
different remote control, you must pair it with the system.
Procedure
1. Press the Bluetooth button on the front of the system.
A pairing screen displays.
2. With your remote control close to the monitor, long press the red Mute button for at least seven
seconds.
3. Follow the instructions on the pairing screen.
The screen displays either a successful or unsuccessful pairing notification.
Note: If pairing is unsuccessful, remove the batteries from the remote control and insert them
again in about five seconds. Move your remote control closer to the system than other
remote controls and try to pair again.
4. To end the pairing process, select Skip Pairing.
Using a Remote Control
Polycom, Inc. 14
To Next Page
Loading...
