System Flags
Polycom, Inc. 195
INTERNAL_SCHEDULER When set to NO (default) this flag prevents potential
scheduling conflicts from occurring as a result of
system calls from external scheduling applications
such as Polycom ReadiManager
®
, and others
through the API.
Set to YES to schedule conference reservations
using an external scheduling application.
Default value: NO
Possible values: YES/NO
HW/VE No
IP_LINK_ENVIRONMENT In H.239-enabled MIH Cascading, when MGC is on
level 1, setting this flag to YES will adjust the line
rate of HD video switching conferences run on the
RealPresence Collaboration Server 1800, 2000 or
4000 from 1920 Kbps to 18432, 100 bps to match
the actual rate of the IP Only HD video switching
conference running on the MGC.
Note: If the flag MIX_LINK_ENVIRONMENT is set to
NO, the IP_ENVIRONMENT_LINK flag must be set
to YES.
Possible values: YES/NO
HW/VE Yes
IP_RESPONSE_ECHO When set to YES, the RealPresence Collaboration
Server will respond to ping (IPv4 and IPv6)
commands.
When set to NO, the RealPresence Collaboration
Server will not respond to ping commands.
Possible values: YES/NO
HW/VE Yes
IPV6_AUTO_ADDRESS_CONFIGU
RATION_METHOD
SLAAC (Stateless Address Auto Configuration) and
DHCPv6 related system behavior is controlled by
setting this flag’s value as required.
Default value: AUTO
Range: AUTO/SLAAC
AUTO—(default) Use DHCPv6 first in case of failure
use SLAAC.
SLAAC—Use SLAAC only.
HW/VE Yes
ISDN_COUNTRY_ CODE The name of the country in which the MCU is
located.
Default value: COUNTRY_NIL
HW No
ISDN_IDLE_CODE_E1 The Idle code (silent), transmitted on the ISDN-video
E1 B channels, when there is no transmission on the
channels.
Default value: 0x54
HW No
General System Flags
Flag Name Description Platform Add?
To Next Page
Loading...
