System Flags
Polycom, Inc. 217
TIMEOUT_BETWEEN_IVR_AND_FI
RST_DIGIT
The timeout between IVR message and DTMF input.
Default value: 99 (seconds)
Range: 0, 1-10, 99
Note: If 99 is configured, the timeout will be identical
to the existing timeout value configured through
Timeout for User Input parameter.
HW/VE Yes
USE_GK_PREFIX_FOR_PSTN_CA
LLS
When set to YES, the gatekeeper prefix is included
in the DTMF input string enabling ISDN-voice
participants to use the same when connecting to
RealPresence Collaboration Server. Applicable for
RealPresence Collaboration Server as a standalone
MCU or as part of a RealPresence DMA solution
deployment.
Default value: NO
Possible Values: YES/NO
HW/VE No
V35_MULTIPLE_SERVICES This flag must be set to YES if the connection of
multiple Serial Gateways to RTM-LAN cards is
required.
The default value of this system flag is NO, enabling
only one Serial Gateway to be supported per
RTM-LAN card.
Possible values: YES/NO
Note: Not Supported in RealPresence Collaboration
Server 1800.
HW/VE Yes
V35_ULTRA_SECURED_SUPPORT When deploying a Serial Gateway S4GW, set this
flag to YES. This flag is applicable regardless of the
security mode.
Possible values: YES/NO
HW Yes
VIDEO_BIT_RATE_REDUCTION_P
ERCENT
Indicates the percentage of actual reduction in bit
rate sent from the RealPresence Collaboration
Server to the endpoint (negotiated bit rate is not
reduced). This flag is applicable only when traffic
shaping is enabled.
Default value: 15
Range: 0-60
ENABLE_RTP_TRAFFIC_SHAPING
HW/VE Yes
VIDEO_ENCODER_CHANGE_LAY
OUT_REQ
This flag contains a new parameter
IsLyncVideoMuted and can take the following
values:
• 0 - To not display any doughboy image for the
Microsoft Lync participants.
• 1 - To display doughboy image for the Microsoft
Lync participants.
General System Flags
Flag Name Description Platform Add?
To Next Page
Loading...
