Polycom SoundStation IP 7000 Setup Guide

Setting Up Your Phone
1 - 15
For information on how to use your phone when it is connected to a
Polycom HDX system, see the User Guide for the Polycom SoundStation IP 7000
Phone, available at www.polycom.com/voicedocumentation. For detailed
information on how to use a Polycom HDX system, see the Polycom HDX
documentation at www.polycom.com/videodocumentation.
Before you set up your phone to connect to a Polycom HDX system, make sure
you have the optional Video Kit (containing a Polycom HDX Microphone
Cable). You use the Polycom HDX Microphone Cable to connect your phone
to the Polycom HDX system.
When you connect your phone to a Polycom HDX system, you do not need to
connect your phone to a power source (even if you want to attach Polycom
HDX Microphone Arrays to your phone). The Polycom HDX system provides
the power source.
To connect your phone to a Polycom HDX system:
1. Connect your phone to the network:
a Connect the 25-foot Network Cable to the LAN jack on your phone.
b Connect the other end of the 25-foot Network Cable to an available
LAN port on the wall or hub/switch device port.
The following figure shows how to connect your phone to the
network.
Note
You can only connect a single-phone setup to the Polycom HDX system. That is,
you cannot connect two phones together (using the Console Interconnect Cable),
and then connect the phones to a Polycom HDX system.
Note
If you want to use a Multi-Interface Module (to access auxiliary audio connectors),
follow the steps for Connecting Your Phone Using AC Power (One Phone, with
Multi-Interface Module) on page 1-5, and then go to step 2.

Polycom SoundStation IP 7000 Specifications

General

Frequency range	160 - 22000 Hz
Telephone dynamic range	85 dB
Ethernet LAN (RJ-45) ports	1
Operating temperature (T-T)	0 - 40 °C
Harmonized System (HS) code	85258900

Weight and Dimensions

Weight	1080 g
Dimensions (WxDxH)	394 x 372 x 73 mm