Polycom SoundStation IP 7000 Setup Guide

Setup Guide for the Polycom SoundStation IP 7000 Phone
2 - 6
Calling
Symptom Problem Corrective Action
There is no dial tone. Power is not correctly applied to
the phone.
Verify that power is correctly applied to the
phone:
• Check that the display is illuminated.
• Ensure the network cable is inserted
properly on the underside of the
phone. (Try unplugging and
re-inserting the cable.)
There is no audible ringing. Ring setting or volume is low. Verify incoming ring setting and volume
level:
• To adjust the ringer volume, press
either
or when the
phone is in the idle state.
• Check that the ring type selected is
not set to Silent Ring. (For more
information, see the User Guide for
the Polycom SoundStation IP 7000
Phone, available at
www.polycom.com/
voicedocumentation.)
Outbound or inbound calling is
unsuccessful.
Place a call to the phone under
investigation. Check that the display
indicates incoming call information.
A “hollow” phone icon displays at
the top left of the screen.
The phone is not registered to a
server.
Ask your system administrator to register
the phone to a server.

Polycom SoundStation IP 7000 Specifications

General

Frequency range	160 - 22000 Hz
Telephone dynamic range	85 dB
Ethernet LAN (RJ-45) ports	1
Operating temperature (T-T)	0 - 40 °C
Harmonized System (HS) code	85258900

Weight and Dimensions

Weight	1080 g
Dimensions (WxDxH)	394 x 372 x 73 mm