Send a Group Page
When you send a group page without selecting a page group, it is automatically sent to the default paging 
group, which is group 1. You cannot send a page while you are in an active call.
Procedure
1. From the Lines screen, select the Paging soft key.
2. From the Paging Groups screen, select a paging group.
3. To begin a page, select Page.
Just before the page starts, you'll hear an alert tone, and then the page begins.
4. Begin speaking.
5. To end the page, select End Page.
Receiving Pages
You receive pages on the paging groups you are subscribed to as well as Group 24 (Priority pages), and 
Group 25 (Emergency pages). When you enable Do Not Disturb, you only receive Emergency pages. 
Non-emergency pages do not display or play on your phone.
How you receive a page depends on the priority of the page, whether you are in an active call, and 
whether your phone is set to receive a page during an active call. When you receive a page, the page is 
always played through the phone's speakerphone. You cannot play a page through your handset or 
headset.
When you enable Do Not Disturb on your phone, you receive only Emergency broadcasts. Non-
emergency broadcasts do not display or play on your phone.
Listen to a Page during an Active Call
How you handle a page when you are in an active call depends on the page priority and whether the 
phone is set up to receive a page during active calls.
The following occurs when you receive a page during a call:
• For Normal pages, the page immediately plays, and you hear audio from both the active call and 
the page.
• For Priority or Emergency page, the page immediately plays. You hear audio from the active call 
and the page.
• If the phone is not set up to receive Normal pages during active calls, the page is displayed as 
Pending.
Note:  You adjust the volume of a Normal, non-emergency page while it plays, and the phone uses the 
adjusted volume for all subsequent non-emergency pages. However, only your system 
administrator can change the volume of an Emergency page.
Procedure
1. Do one of the following:
• For pages that play automatically during a call, hold the call to hear only the page.
• For Pending pages, select Accept or hold the call.
Accessing, Sending, and Broadcasting Messages
Polycom, Inc. 108