Polycom® VVX® 400 and 410 Business Media Phones User Guide
18
To park a call:
Tap the Park softkey
A message will announce to someone on your PBX where (what extension) to pick up the
parked call. You can publicly announce (page) or call to notify someone where (what extension)
they can pick-up the parked call. To pick-up the parked call, they dial the parked call extension.
Ending Calls
To quickly end an active call, replace the handset. Or from Lines or Calls view, press End Call.
If you’re in Calls view, be sure to highlight the call first.
Note: How Do I End a Held Call?
A call must be active to end it. To end a held call: From Calls view, select the held call to
highlight it, press Resume, and then press End Call.
Using Headsets
You can connect an analog headset to your phone. If an analog headset is connected and in
use, glows green.
If you use a headset, you can set up your phone so that all calls use your headset (see Enabling
Headset Memory Mode). If you use a headset that supports electronic hookswitch (EHS), you
can press the hookswitch button to place, answer, and end calls. In addition, you may be able to
mute calls and control volume from your headset.
Web Info: More Information About Headsets
For information on how to connect a headset to your phone, see the Quick Start
Guide for your phone, available by navigating to your phone from the Polycom
Business Media Phones Web page.
For information on your headset’s features, as well as how to sync your headset
with your phone, see your headset documentation.
For a list of supported headsets, see the Headset Compatibility List (Technical
Bulletin 37477). For detailed information about how to use electronic hookswitch,
see Using an Electronic Hookswitch (Technical Bulletin 35150). All these
documents are available on the Polycom® Profiled UC Software Features and
Polycom® Engineering Advisories and Technical Notifications support pages
To Next Page
Loading...
Need help?
General