Safety Recommendations
It is the user’s responsibility to read and understand all instructions and safety precautions included in this
manual prior to installing or operating this equipment. Contact our Customer Service Department with any
questions regarding the operation of this Chiller or the information contained in this manual.
WARNING: All warning labels should be carefully observed. Never remove or obstruct a warning label.
WARNING: Installation, operation, or maintenance of this equipment should be performed in strict
accordance with the instructions outlined in this manual. Failure to follow those instructions may
increase the risk of personal injury, damage the equipment, and/or void the warranty.
WARNING: Be sure to remove power from the equipment, reclaim the refrigeration charge, and relieve
any residual pressure before cutting into the refrigeration system.
WARNING: Do not attempt to operate leaking or damaged equipment.
WARNING: Service should only be performed by fully qualified personnel. Extreme caution is required
as hazards are present when servicing this equipment.
WARNING: Do not attempt to override the power interlock switch or any other safety feature on this
equipment.
WARNING: Disconnect electrical power before moving unit. Keep unit upright when moving. Always
follow your company’s procedures and practices regarding safe lifting and relocation of heavy objects.
WARNING: Make sure the equipment’s main power switch is in the OFF position before connecting or
disconnecting power. Follow all applicable electrical and safety codes and procedures when connecting
power to the unit. Electrical connections should be made by an authorized electrical installer.
WARNING: This equipment must be properly filled with cooling fluid before use and properly drained
before moving or service.
WARNING: Use only fluids that comply with safety, health, and equipment compatibility requirements.
Read the safety data sheet for the fluid being used carefully before use.
CAUTION: Always operate this equipment within the stated design specifications.
110-279 6
To Next Page
Loading...
Need help?
General
