3-2
3 First Steps
Available as an option:
•
TMS-A-305 Calibration Set
•
A-PST-200S XY Positioning Stage*
•
A-CTR-110 Axis Controller*
•
A-TAB-AIR-01 Optical Table, pneumatically vibration-damped*
•
A-TAB-ELC-01 Optical Table, electronically vibration-damped*
•
A-WST-001 Workstation*
Equipment provided by the customer (if no vibration-damped table is used):
•
Base plate (breadboard) for fixing the stand, with M6 thread, 25 mm grid
or 1/4"-20UNC thread, 1” grid
Inspection
Pay attention to the following steps when unpacking:
1. Check the packaging for signs of unsuitable handling during transport.
2. After unpacking, check all components for external damage (scratches,
loose screws, damaged components etc.).
3. In the case of a wrong delivery, damage or missing parts, immediately
inform your local Polytec representative, stating the serial numbers of the
instruments. The serial number can be found on the name plate. You will
find the name plate on the instruments as well as on the inside cover of
these operating instructions.
4. Carefully retain the original packaging in case you have to return the
instruments.
To Next Page
Loading...
