3-14
3 First Steps
3.3.2 Mounting the Sensor Head without the Stand
CAUTION!
Damage to sensor head caused by incorrect handling!
To prevent the sensor head from distorting during assembly, you need to fit it
accurately and flat on the supporting surface.
» Use a supporting surface which is as flat as possible.
» Place the sensor head only on the three supports near the attachment
points (marked red, refer to F
IGURE
5.4).
» Screw in the screws only to the maximum thread reach.
To mount the sensor head at a desired measurement location, fix the sensor
head on its attachment points (marked red, refer to F
IGURE
5.4) using three
M6 x 6 screws.
To Next Page
Loading...
