Postek G2000e - Software Installation Guide

G2000e/G3000e/G6000e User’s Manual Chapter 3: Operations and Settings
35
increase the value. After finding the appropriate value for offset, press the [FEED/Calibration]
button to save the new value.
• If an error occurred during encoding, after voids the failed RFID label, the printer will try
another attempt for the unfinished encoding on the next RFID label. If the second attempt also
fails, the printer will pause the print job and display the error message. Press the
[CANCEL/ Reset] button to cancel the print job.
• RFID calibration must not be performed after adjusting the offset value manually, the manually
set offset value will be overridden otherwise.
3.4 Installing Windows Driver and Label Editing Software
The printer driver supports Win10/8/7. To access to the driver, please scan the QR code on the
Quick Start Guide or visit POSTEK website: http://www.postekchina.com.
Each printer also comes with a BarTender UltraLite edition software. To access to the software and
the directions for use, please scan the QR code on the Quick Start Guide or visit POSTEK website:
http://www.postekchina.com.
Please uninstall the old version driver before driver updating.