Postek G2000e - Setting Menu

G2000e/G3000e/G6000e User’s Manual Chapter 3: Operations and Settings
23
The information includes: The printer’s model, firmware version, hardware’s parameters and its
current status, thermal transfer/direct thermal mode, font list, etc.
Reset to Factory Settings
When the printer is on standby, press and hold the [CANCEL/ Reset] button (hold for around 4
seconds), all three indicators will start blinking (if no further input is detected for the next 8 seconds
then the printer will return to standby). Release the [CANCEL/ Reset] button and press it again to
initiate the reset process, the [READY] indicator would be off and the rest two indicators would
blink simultaneously, when all three indicators are lit and return to a steady state, the reset process
is complete.
The number of printed labels (pcs) and printed length (m) cannot be restored to factory default
value.
3.1.4 Setting Menu
Button Functions
Table 3-4 Button Function Description
Button
Function
Description
Combination:
[PAUSE/Self Test]+
[FEED/Calibration]
Entering the Main Menu
Press and release [PAUSE/Self Test], then
press and hold [FEED/Calibration] for 4
seconds
[PAUSE/Self Test]
Item/Parameter Selection
Descending Item/Parameter selection
[CANCEL/ Reset]
Item/Parameter Selection
Increasing Item/Parameter selection
[FEED/Calibration]
Confirmation
Confirm selection
Items to be set and operating guide
Table 3-5 Main Menu Description
Main Menu
Description
EXIT
Exit the setup menu
PRINT
DARKNESS
When set as “0”, the printer would either follow the command settings or the
default values (10/20 or 15/30 for PRINT DARKNESS, 2ips for PRINT
SPEED) when the relevant command settings are absent;
When set as other values, the printer would follow the settings in the printer
LCD menu, command settings would not take effect.
PRINT SPEED
LANGUAGE
Options: CHINESE, ENGLISH, ESPA
Default: ENGLISH
PRINT MODE
Options: THERMAL TRANSFER, DIRECT THERMAL
Default: THERMAL TRANSFER