Postek G2000e - Page 29

G2000e/G3000e/G6000e User’s Manual Chapter 3: Operations and Settings
24
out
Main Menu
Description
TEAR MODE
Tear-off Mode
Options: ENABLE, DISABLE
Default: ENABLE
CUT MODE
Cutter Mode/Peeler Mode
Options: ENABLE, DISABLE
Default: DISABLE
PEEL MODE
SENSOR TYPE
Media Sensor Type
Options: TRANSMISSIVE, REFLECTIVE
Default: TRANSMISSIVE
BAUD RATE
Options: 9600, 19200, 38400, 57600, 115200
Default: 38400
PARITY BIT
Options: NONE, ODD, EVEN
Default: NONE
DATA BITS
Options: 7 BITS, 8 BITS
Default: 8 BITS
TEAR OFFSET
Adjust the media stop position over the tear-off bar after printing under
tear-off mode.
• Set higher values to move the media stop position out.
• Set lower values to move the media stop position in.
FEED OFFSET
Adjust the media stop position.
• Set higher values to move the media stop position out.
• Set lower values to move the media stop position in.
Feeding
Direction
Default
Tear Line
in
Feeding
Direction
Original stop
position
in
out