Postek G2000e - Setting Operation Mode

G2000e/G3000e/G6000e User’s Manual Chapter 3: Operations and Settings
29
3.1.5 Setting Operation Mode
• Tear-off Mode is the default operation mode and is the recommended mode to be used in
conjunction with RFID functionalities. Turning it off may affect the normal usage of RFID
functionalities.
• Cutter and Peeler Mode are built upon Tear-off Mode, switching Cutter or Peeler Mode on will
automatically enable Tear-off Mode.
• The Printhead module needs to be closed before adjustment can be made to the settings menu.
Tear-off Mode
The steps to set the printer to Tear-off Mode are as follows:
1. Connect the printer to PC using the preferred communication port and connect the printer
power supply.
2. Install the media and ribbon as shown above, turn on the printer and wait for the printer to boot
normally.
3. After “READY” is displayed on the screen, press the [PAUSE/Self Test] button, and then press
and hold [FEED/Calibration] button to enter the setting menu. Find “TEAR MODE” in the
menu and select it, select “ON” to enable Tear-off Mode.
4. Find “EXIT” in the menu and press the [PAUSE/Self Test] button to exit the setting menu.
5. Press and hold the [FEED/Calibration] button (hold for around 4 seconds), the printer will
automatically feed labels and the media calibration is done.
6. Create the label template on your PC using the Bartender label software. Click at “print” to
initiate the print job. After the print job is complete, the gap between the labels would stop at
the edge of the tear-off bar, so the label can be torn off easily.
7. If the stopping position of the label needs to be adjusted, press the [PAUSE/Self Test] button,
and then press and hold [FEED/Calibration] button to enter the setting menu. Select “TEAR
OFFSET” and adjust the value accordingly.
Peeler Mode (Peeler accessory required)
The steps to set the printer to Peeler Mode are as follows:
1. Connect the printer to PC using the preferred communication port and connect the printer
power supply.
2. Install the media and ribbon as shown above, turn on the printer and wait for the printer to boot
normally.
3. After “READY” is displayed on the screen, press the [PAUSE/Self Test] button, and then press
and hold [FEED/Calibration] button to enter the setting menu. Find “PEEL MODE” in the
menu and select it, select “ON” to enable Peeler Mode.
4. Find “EXIT” in the menu and press the [PAUSE/Self Test] button to exit the setting menu.