30
5. Press and hold the [FEED/Calibration] button (hold for around 4 seconds), the printer will
automatically feed labels and the media calibration is done.
6. Create the label template on your PC using the Bartender label software. Click at “print” to
initiate the print job.
7. Remove the peeled label, and the printer will resume printing.
8. If the peeling position of the label needs to be adjusted, press the [PAUSE/Self Test] button,
and then press and hold [FEED/Calibration] button to enter the setting menu. Select “PEEL
OFFSET” and adjust the value accordingly.
Cutter Mode (Cutter accessory required)
The steps to set the printer to Cutter Mode are as follows:
1. Connect the printer to PC using the preferred communication port and connect the printer
power supply.
2. Turn on the printer and wait for the printer to boot normally.
3. After “READY” is displayed on the screen, press the [PAUSE/Self Test] button, and then press
and hold [FEED/Calibration] button to enter the setting menu. Find “CUT MODE” in the menu
and select it, select “ON” to enable Cutter Mode.
Peeler Mode and Cutter Mode can’t be both enabled at the same time, please turn off Peeler
Mode first before switching Cutter Mode on.
4. Find “EXIT” in the menu and press the [PAUSE/Self Test] button to exit the setting menu.
5. Reset the cutter before use. To reset, press and hold the [CANCEL/ Reset] button until three
indicators start blinking (This process takes around 4 seconds), release the button and press it
again to finish the reset.
Please reset the cutter before installing the media to prevent any issues with installation.
6. Turn off the printer. Load the ribbon and media in the order as shown above. Thread the media
through the opening on the cutter as shown in Figure 3-2.
To Next Page
Loading...
