Stand alone drives
Frames 5 to 11 are designed to be placed over a technical floor. If necessary, there are optional plinths
that increase the height of the drive from 1710 mm to 2000 mm or 2200 mm. The floor must guarantee
a non-flammable, solid, plain and level surface to the drive, a minimum safety distance around it and
esay cable access. The maximum allowed slope is 1cm per 6 meters. The installation site should be
level since the cabinet is not equipped with a height-adjustable base. The walls adjoining the drive
must be of a non-flammable material. Attach the SD750 to the wall or floor using the L brackets on both
sides of the drive. The brackets have Ø11 hole diameters and are located on the legs and rear.
Wall or floor fixation
It is recommended to construct a cable duct to get the cables to the input / output connections. The
duct width must not exceed 300 mm and the ground contact surface must withstand the weight of the
cabinet that falls on its legs.
To Next Page
Loading...