Reception and Storage
The SD750 is carefully tested and perfectly packed before delivering. In the event of transport damage,
please ensure that you notify the transport agency and Power Electronics: 902 40 20 70 (International
+34 96 136 65 57) or your nearest agent, within 24h from receipt of the goods.
Make sure model and serial number of the drive are the same on the delivery note and unit.
Drive should be stored in a sun and moisture protected space and with an ambient temperature between
-40°C and +70°C, < 95 RH without condensation. It is recommended not to stack more than two units.
Handling and Transportation
Only the transport methods described in this document or in the delivery notes are permissible. Any other
transport method or system could damage the unit.
SD750 is delivered vertically. Frames 1 and 2 are delivered in a cardboard box. From frame 3 they are
delivered fastened to a wooden pallet. Frames 3 and 4 are covered with a cardboard box and from frames
5 with a wooden box. Depending on the method of transportation, the drive is supllied wrapped to be
protected against dust. Place the entire pallet as close as possible to the installation site before removing
the wooden box to prevent damage to the drive during transportation.
It is mandatory to carry the drive with a pallet truck, a forklift track or a crane, taking into account the load
distribution and its center of gravity. Check the size and weight of the VFD to choose a proper equipment
that can lift a higher weight.
Remove the drive packaging carefully (do not use sharp tools). After removing the packaging, please
check the material inside. Verify that the number of items included in the package is in accordance with
the inventory. In case of receiving spare parts with the product, please separate it and store it in a safe
place. It should not be exposed to vibrations, falls or moisture.
To Next Page
Loading...
Need help?
General
