powersoft K Series - Removing the Amplifier Output Board; Amplifier Output Board Removal Procedure

INDEX
22
K6 K8 K10 K20 | SERVICE MANUAL
Unplug the faston between the power supply board and
the amplier output board. (Fig. 23)
7. Removing the Amplifier Output Board:
Before removing the amplier output board, please
proceed in discharging the power supply capacitors as
illustrated in chapter 3.
Remove the rear panel’s connectors by unscrewing all 10
screws marked in (Fig.21)
Remove the RJ45 connector of the RS485 port. (Fig. 22)
(Fig. 21)
(Fig. 22)
(Fig. 16)
Once these 7 screws have been removed, remove the
amplier output board heat sink screws marked in (Fig.
24) with a 2,5mm hexagonal screwdriver.
(Fig. 24)
(Fig. 23)