viii | X Series | User guide
DECLARATIONS ABOUT WiFi
This device contains WiFi module
FCC ID: RYK-WUBR508N
IC ID: 6158A-WUBR508N
FCC statement
This equipment contains a WiFi module that has been tested and found
to comply with the limits for a Class A digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
f Reorient or relocate the receiving antenna.
f Increase the separation between the equipment and receiver.
f Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority to
operate this equipment.
This equipment contains a device that complies with Part 15 of the FCC
Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received, including inter-
ference that may cause undesired operation.
This equipment is restricted to indoor use when operated in the 5.15 to
5.25 GHz frequency range. The end-user is responsible to select a spe-
cific transmission channel in order to satisfy outdoor wireless regulation
requirements.
This equipment contains a device that is compliant with SAR for gen-
eral population/uncontrolled exposure limits in ANSI/IEEE C95.1-1999
and had been tested in accordance with the measurement methods and
procedures specified in OET Bulletin 65 Supplement C. This equipment
should be installed and operated with minimum distance 20 cm between
the radiator and your body.
IC statement
This equipment contains a device that complies with RSS-210 of the
Industry Canada Rules. Operation is subject to the following two condi-
tions:
1. this device may not cause interference and
2. this device must accept any interference, including interference
that may cause undesired operation of the device.
IC Radiation Exposure Statement
This equipment contains a device that complies with IC radiation expo-
sure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20 cm between
the radiator & your body.
Note: the manufacturer is not responsible for any radio or tv interference
caused by unauthorized modifications to this equipment. Such modifica-
tions could void the user’s authority to operate the equipment.
EU declaration
Powersoft hereby declares that the WiFi module contained in this/these
product(s) is/are in compliance with the essential requirements and oth-
er relevant provisions of Directive 2006/95/EC,1999/5/EC. This device is
a 2.4 and 5 GHz wideband transmission system (transceiver), intended
for use in all EU member states and EFTA countries, except in France and
Italy where restrictive use applies.
In Italy the end-user should apply for a license at the national spectrum
authorities in order to obtain authorization to use the device for setting
up outdoor radio links and/or for supplying public access to telecom-
munications and/or network services.
This device may not be used for setting up outdoor radio links in France
and in some areas the RF output power may be limited to 10 mW EIRP
in the frequency range of 2454 – 2483.5 MHz. For detailed information
the enduser should contact the national spectrum authority in France.
This equipment contains a device that is a Class A product. In a domestic
environment, this product may cause radio interference, in which case
the user may be required to take adequate measures.
Explosive device proximity warning – Do not operate a portable trans-
mitter (such as a wireless network device) near unshielded blasting caps
or in an explosive environment unless the device has been modified to
be qualified for such use.
This device can be operated in the EU without restrictions indoor. The
end-user is responsible to select a specific transmission channel in order
to satisfy outdoor wireless regulation requirements.
This CE marking is valid for EU non-harmonized telecommunications
products
R&TTE Directive (1999/5/EC) issued by the
Commission of the European Community.
European representative:
Powersoft S.p.A.
via E. Conti, 5
50018 Scandicci (FI), Italy
To Next Page
Loading...
