EFX 885, 835, 825
Service Manual 20039-166
Page 146
©2011 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
12. Carefully pull the old interconnect cable out of the mid-point access hole while feeding the new
interconnect cable into the unit. When the new cable is fully into the unit, remove the tape and discard the
old interconnect cable. Connect the lower interconnect cable to the mid-point connector and push them
into the access hole.
13. Connect the new interconnect cable to the lower PCA.
14. Check the operation of the EFX as described in Section Seven.
To Next Page
Loading...
