Precor EFX 835 - P20 Displaying Information

EFX 885, 835, 825
Service Manual 20039-166
Page 98
©2011 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Procedure 6.2 P20 Displaying Information
The information display will access the following data;
 Odometer
 Hour Meter
 U-Boot Software
 U-Base Software
 Lower Software
 Usage log
 Error Log
Procedure:
1. Use the:
 INPUT UP and INPUT DOWN keys to move though the different Information.
 GO key to select the information.
 WORKOUTS/PROGRAMS key to back up one level until reaching Banner state.
 PAUSE/RESET key to return the unit to Banner state from anywhere in the menus.
Displaying Information Menu - Table
Displayed
Information
Action
Description
Odometer
At the Banner press PAUSE/RESET,
INPUT UP, and ENTER
sequentially.
ODOMETER will be displayed.
Press the GO key to select.
The odometer will display distance in STRIDES only.
The odometer is also used to provide the distance stamp for the error code log
Press the WORKOUTS/PROGRAMS
key to exit the Odometer.
Hour Meter
Press the  key to go to Hour Meter.
HOUR METER will scroll across the display.
Press the GO key to select.
The operating time of the unit will be displayed as 12345 HOURS. The
operating time is defined as total amount of time that the unit has operated in
program modes. The hour meter is also used to provide the time stamp for the
error code log.
Press the WORKOUTS/PROGRAMS
key to exit the Hour Meter.
U-Boot
Software
Press the  key to go to U-Boot
Software.
U-Boot Software will scroll across the display