Precor EFX 835 - Diagnostic Software Menu - Table

EFX 885, 835, 825
Service Manual 20039-166
Page 58
©2011 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
3. See Diagnostic Software Menu Table
Diagnostic Software Menu - Table
Test
Type
Action
Descriptions
Display
Test
Press keys PAUSE,5,1,7,6,5,7,6,1,
sequentially.
Hardware Validation will scroll across the display followed by DISPLAY TEST.
Press OK key
will illuminate on the display. Check the display to ensure
that all LED segments are illuminated.
Press the OK key four more times
To display the remaining LED groups. Check each display group to ensure that all LED
segments are illuminated.
Press the BACK key to return to
Hardware Validation
Keyboard
Test
Press the  key
KEYBOARD TEST will scroll across the display
Press the OK key
A representation of all of the keys on the console will be displayed. Pressing a key on the
console will cause the illuminated representation of that key to turn off. Press all of the
keys on the console to ensure that all of the keys are functioning.
Press and hold the BACK key for 5
seconds to return to Hardware
Validation
Heart Rate
Test
Press the  key
HEART RATE will be displayed.
Press the OK key
Grasp both of the heart rate grips on the handlebar, after a couple of seconds the heart rate
will be displayed in the heart rate and smart rate displays.
Use chest strap transmitter or a test transmitter to test the wireless heart rate function,
after a couple of seconds the heart rate will be displayed in the heart rate and smart rate
displays.
Press the BACK key to return to
Hardware Validation
Machine
Test
Press the  key
MACHINE TEST will scroll across the display.
Press the OK key
You may now proceed to one of the four Machine tests. Press the  key once to access the
Brake test, twice to access the Incline test, three times to access the RPM test, or four times
to access the Battery test.
Press the  key
BRAKE TEST will be displayed.
Press the OK key
The console will display the power bits (PWRB). Changing the resistance , keys will
change the power bit settings.
Press the BACK key to return to
MACHINE TEST
Press the  key
INCLINE TEST will be displayed.
Press the OK key
The console will display the analog to digital (A/D) incline position number and the incline
position in percent of incline. Press the inline , keys to operate the incline throughout
its range.
Press the BACK key to return to
MACHINE TEST
Press the  key
RPM Test will be displayed.
Press the OK key
The console will display the Pulse. The pulse is showing a count of zero crossings from the
generator. RPM shows a software averaged version of pulse.