Precor EFX 835 - P30 Displaying Information

EFX 885, 835, 825
Service Manual 20039-166
Page 60
©2011 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Procedure 5.2 P30 Displaying Information
The information display will access the following data;
 Odometer
 Hour Meter
 U-Boot Software
 U-Base Software
 Lower Software
 Metric Board Software
 Serial Number
 Usage log
 Error Log
Procedure
1. See Displaying Information Menu - Table
Displaying Information Menu -Table
Displayed
Information
Action
Description
Diagnostics
Information
With the PRECOR banner scrolling,
press the keys PAUSE,6,5,
sequentially.
Use the , keys to move to the
desired display shown in the list
above.
DIAGS _ INFORMATION will scroll across the display. Followed by
ODOMETER.
Odometer
Press the OK key.
The odometer will display distance in STRIDES only.
Note: The odometer data is stored in non-volatile memory on the upper PCA.
If the upper PCA is replaced the odometer data will be lost.
Press the BACK key to exit the
odometer display.
Hour Meter
Use the , keys to move to
move to HOUR METER.
Press the OK key.
The operating time of the unit will be displayed as 12345 HOURS. The
operating time is defined as total amount of time that the unit has operated in
program mode. The hour meter is also used to provide the time stamp for the
error code log.
Press the BACK key to exit the
HOUR METER display.
U-Boot SW
Use the , keys to move to
move to U-BOOT SW.
Press the OK key.
The software part number will be displayed as XXXXX-XXX.