Precor EFX 835 - Console Access Panel; Maintenance Access Hook

EFX 885, 835, 825
Service Manual 20039-166
Page 66
©2011 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
6. Remove the two screws that fasten the access panel to the console. See Diagram 5.5.3
Diagram 5.5.3 Console Access Panel
7. Remove the back access Panel:
a. Treadmills: Lift the console off the maintenance hook and then position the console so that the back
panel is accessible and remove the back cover.
b. AMT’s, EFX’s, CLM’s, UBK’s, and RBK’s: Tilt the console forward on the maintenance access hook on the
dash weldment and remove the back. See Diagram 5.5.4.
Diagram 5.5.4 Maintenance Access Hook
8. Remove the Heart Rate PCA. See Procedure 5.7, Removing Heart Rate PCA.
9. Disconnect the Heart Rate Cable from the Heart Rate PCA.
10. Disconnect the Data cable, Auto Stop cable (Treadmill only), Stop Key cable (Treadmill only), Ground wire and
the CSAFE cable (if in use) from the Upper PCA. See Diagram 5.5.5. Remove the console from the maintenance
access hook and place it on a flat work surface.
Mounting Plate Hook
Access Panel Mounting
Screws
Access Panel Mounting
Screws