Precor EFX 835 - P80 TV Settings; Channel Guide; To Scan for Available Channels; To Delete a Channel from the Channel Guide

EFX 885, 835, 825
Service Manual 20039-166
Page 22
©2011 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Procedure 3.9 P80 TV Settings
The display settings allow you to configure Measurement units, Standby Mode Delay, Time Zone, and Closed
Captioning.
1. Refer to Procedure 3.1 Settings, to access the TV Settings menus.
2. To select a TV Settings setting, touch on an item in the TV Settings menu.
The TV Settings are:
 Channel Guide
 Region
 Default Channel
 Skip Unnamed Channels

Channel Guide
The following procedure discusses how to set up the channel guide and how to configure audio and video playback.
Note: The correct region must be set before you scan for available channels. To confirm the settings, touch Region, a list
of regions will be displayed. Confirm that the radio button next to the appropriate region for your area is selected. If the
highlighted region is incorrect, touch on the radio button next to appropriate region. Touch OK, and then touch  BACK
to the TV Settings menu.
To scan for available channels:
1. Touch Channel Guide from the TV Settings menu.
2. Touch Scan Channel.
The console scans for available channels and when the scan is finished all available channels will be displayed on the
screen.
To delete a channel from the Channel Guide:
1. On the Channel Guide screen, touch the listing for the channel you want to delete.
2. Touch the DELETE button.
3. When asked Are you sure? verify that you want to proceed, then touch YES.
4. Touch  BACK to Settings. Procedure 3.1.
Settings
Default
Detail
Channel Guide
Scan Channels
Region
United States
Select the appropriate region for your location.
Default Channel
Set a default channel for the equipment. This is the channel that will display
when the TV is turned on.
Skip Unnamed Channels
On
ON/OFF