Precor EFX 835 - Page 63

EFX 885, 835, 825
Service Manual 20039-166
Page 63
©2011 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Press the OK key to save selection and exit to Club
Settings.
SET MAX PAUSE TIME will be displayed.
Set Max
Pause
Time
Press the OK key.
Use the , keys to select the maximum time the
unit will remain in paused before resetting.
As the , keys are pressed, the displayed value increments or
decrements between 1 and 120 seconds. If an arrow key is held down
then the value changes slowly at first and then at an increasing rate.
Press the OK key to save selection and exit to Club
Settings.
SET COOL DOWN TIME will be displayed.
Set Cool
Down
Time
Press the OK key.
Use the , keys to select the cool down time.
As the , keys are pressed, the displayed value increments or
decrements between 0 and 5 minutes.
Press the OK key to save selection and exit to Club
Settings.
SET METRIC DEFAULTS will be displayed.
Set Metric
Defaults
Press the OK key.
Use the , keys to select the default settings
that will be displayed during a workout.
A list of available default settings will be displayed, including:
 OFF
 % COMPLETE
 TIME IN ZONE
 SEGMENT TIME REMAINING
 AVERAGE SPEED
 CALS/MIN
 CALS/HR
 WATTS
 METS
 TARGET HR
 AVE HEART RATE
 SHOW ALL
Press the OK key to save selection and exit to Club
Settings.
Set Crossramp Auto-Level will be displayed.
Set
Crossramp
Auto-
Level
Press the OK key.
Use the , keys to select height the crossramp
will return to when after a workout.
As the , keys are pressed, the displayed value increments or
decrements between XRAMP 1 - 20. If an arrow key is held down then
the value changes slowly at first and then at an increasing rate.
Press the OK key to save selection and exit to Club
Settings.
HIDDEN PROGRAMS will be displayed.
Set
Hidden
Programs
Press the OK key.
Use the , keys to select the either Show
Programs or Hide Programs.
A list of available default settings will be displayed, including:
 SHOW PROGRAMS
 HIDE PROGRAMS
Press the OK key to save selection and exit to Club
Settings.
SET CUSTOM PROGRAMS will be displayed.
Set
Custom
Programs
Press the OK key.
Pressing the , keys changes the
active column. Pressing the
corresponding , crossramp keys
changes the crossramp level for that
column.
When this function is initiated, the currently stored custom
program (#1 or #2) is displayed in the matrix. The first
column is active; all the LEDs in that column blink. The
crossramp level for that column is displayed in the message
bar.
Press the OK key to save program and exit to Club
Settings.
Press the PAUSE key exit Club Settings.