Precor SPINNER CHRONO POWER User Manual

7. Place the LPCA bracket into position on the frame cross member bracket and secure
using the two 4 mm hex key bolts (2x) and washers (2x). Fully tighten the fasteners.
8.
Reconnect the Strain Gauge (J1) cable connector, then the Data COMM (J3) cable
connector and last the Generator (J5) ,cable connector.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 94
5 Replacement Procedures
Drive Belt, Generator Belt, and Flywheel Replacement

Precor SPINNER CHRONO POWER Specifications

General

Brand	Precor
Model	SPINNER CHRONO POWER
Category	Exercise Bike
Language	English