Handlebar Adjustment Knob Replacement
About
This procedure provides instruction to remove and install the Handlebar Adjustment Knob.
Procedure
Review entire procedure before starting.
Removal Instructions
1. Remove the handlebar assemble, see "Handlebar Assembly Replacement" on
page100.
2. Fully tightening the handlebar adjustment knob. This will push the locking nut slightly
above the bottom edge of the adjustment knob bracket mounting hole enough to
place a thin wall deep socket onto the 5/16" locking nut.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 104
5 Replacement Procedures
Handlebar Adjustment Knob Replacement
To Next Page
Loading...
Need help?
General
