3. Make final adjustments to the data COMM cable slack and fully tighten the fasteners
handlebar post cable cover.
4. Ride the bike and verify that the console powers on and is operating normally.
l
Make sure the WATTS, RPM, TIME, DISTANCE, and INTERVAL metrics are
reporting correct information.
5. Verify the bike operation per "Operation Verification Checklist" on page14 and return
to service.
Procedure - (Spinner® Climb™ models only)
Review entire procedure before starting.
Removal
1. Pull the handlebar height adjust pop pin and carefully lift the handlebar post from the
top of the frame weldment, see the Operator's Guide for more information.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 109
5 Replacement Procedures
Handlebar Post Removal