Spinning® Studio Console
About
The Spinning
®
Studio Console is used on the Spinner
®
Climb™ indoor cycle. This console
is also used on Precor Spinner
®
Ride™, Spinner
®
Shift™, and Spinner
®
Rally™ model
indoor cycles.
Refer to the SPINNING STUDIO "Owner's Manual" for the latest console install-
ation, use, and service information.
l
Operator's Guide
Features
l
Battery Powered Console and Cadence Sensor: The console is powered by 3 -
AAA batteries and the Cadence sensor uses a CR2032 lithium coin cell battery.
l
ANT+
1
connectivity: The console supports ANT+ wireless heart rate monitor chest
straps (however the Polar or Suunto ANT+ brand heart rate monitor chest straps are
not supported).
l
Program Memory: The console maintains programming code during battery replace-
ment.
1
ANT+ (pronounced ant plus) is a wireless protocol for monitoring sensor data such as a
person's heart rate or a bicycle's tire pressure
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 185
9 Consoles
Spinning® Studio Console
To Next Page
Loading...
Need help?
General
