Precor SPINNER CHRONO POWER - Parts; Procedure; Replacement Procedures; Replacement Procedure - (Spinner Chrono Power Models Only)

Parts
QTY Part Number Description Image
2 PPP00RX2809393M000 Push Mount Cable Tie
4 General purpose Cable Zip Tie (6- 8 in)
1 PPP00RX10L93XSX000
(1)
Self-AdhesiveCable
Clip
Notes:(1) Only needed if the cable clip is loose, damaged, or missing.
Procedure
Replacement Procedures
l
Spinner
®
Chrono™ Power models
l
Spinner® Climb™ models only models
Replacement Procedure - (Spinner
®
Chrono™ Power models only)
Review entire procedure before starting.
Removal
1. Remove front and rear belt guard covers, see "Belt Guard Cover Replacement" on
page47.
2. Cut the four cross member cable-ties (4x) that secure the strain gauge cable to the
cross member. Discard the cable ties.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 59
5 Replacement Procedures
Brake Caliper Assembly Replacement