Make sure that the cable bolt is threaded a minimum of seven threads into
the selector stem, and the locking jam nut is tight. (Refer to the following
figure.)
Figure 3: Cable bolt must extend a minimum of seven threads into the selector
stem
Check Warning and Instructional Labels
Inspect warning and instructional labels daily to make sure that all the
information can be clearly read. If any portion is not visible or part of the label
is not adhered properly, replace that label immediately (refer to Obtaining
Service for purchase information).
Clean labels as needed with a mild soap and water solution in a spray bottle,
and dry thoroughly with a soft cloth.
The following figure shows an example of a user instructional label.
Figure 4: Example instructional label for the Vitality™ Series Selectorized Line