Vitality Series Selectorized Line Leg Press/Calf Extension Assembly Guide: Assemble the Equipment 12
Apply the Instructional Label, Outside Precor Equipment Label, and
General Warning Label
1. Attach the Instructional label to the inside shroud under the top cap. The
label should be aligned with the left and right edges of the tray on the top
cap. There are small marks on the lower lip of the top cap to indicate the
proper label position.
2. Attach the Precor Equipment label to the outside shroud by centering it
under the top cap. There are small marks on the lower lip of the top cap to
indicate the proper label position.
3. Attach the General Warning label to the left tower frame upright. The top of
the label should be 56 mm (22 inches) above the floor.
Figure 13: Label application