PRESONUS STUDIOLIVE 16.4.2 - Channel Controls: Select

8686
PreSonus StudioLive
™
16.4.2
Quick Start:
Level
Setting
Overview Hookup Controls Connecting
to a
Computer
Tutorials Technical
Information
Trouble-
shooting
and Warranty
Scenes, Presets,
and System Menu
7 Software: Universal Control, SL Remote, Capture, Studio One Artist
Software: Universal Control,
SL Remote, Capture,
and Studio One Artist
7.3 Using StudioLive Remote for iPad
®
StudioLive Remote for iPad provides an unprecedented level of remote
control over your StudioLive. With SL Remote, you can adjust level, pan,
dynamics, bus routing, eects mixes, aux mixes, and GEQ setting from
an Apple iPad via a wireless network. All you need is a computer with
Wi-Fi capabilities and an Apple iPad, and you’re ready to get started.
Please Note: This section describes the functionality of
SL Remote with all three StudioLive series mixers. All
Screen Shots are from the StudioLive 24.4.2.
7.3.1 Networking your iPad and Computer
To use StudioLive Remote, you must rst install Universal Control on,
and sync your StudioLive to, a Windows or Mac computer that has both
a FireWire connection and a wireless card. Once you have connected
and synced your StudioLive to VSL on your computer, the next step is to
create an ad hoc wireless network between your iPad and your computer.
An ad hoc, or “peer-to-peer,” network is a very simple network
involving at least two systems: in this case, the computer to which
your StudioLive is connected and an Apple iPad. Unlike the usual local
area network (LAN) that you use to connect multiple computers to
the Internet or to a shared le server, no server or router is needed.
Creating an ad hoc wireless network between your computer and your
iPad is quick and easy. The network will allow you to remote-control VSL,
and hence your StudioLive, from an iPad, using StudioLive Remote.
STEP 1: Creating an Ad Hoc Network on Your Computer
Windows Vista
1. Open Start>Connect to.
2. Click “Set up a connection or network.”
3. Select “Set up a wireless ad hoc network” and click Next.
4. Enter the new network name such as “StudioLive.”
5. Enter a Security key or password. For the best security,
include letters, numbers, and punctuation.
6. Check “Save this Network.”
Windows 7
1. Open Start>Control Panel.
2. Click “Network and Internet.”
3. Click “Network and Sharing Center.”
7.3 Using StudioLive Remote for iPad