Primedic DefiMonitor XD - Loading the PRIMEDIC Akupak

Preparatory measures before (initial) start-up
METRAX GmbH
DefiMonitor XD 21324 / GB / K05
43 / 116
5.4 Loading the PRIMEDIC™ AkuPak
PRIMEDIC™ AkuPak can be charged in two different ways:
• in DefiMonitor XD when connected to the mains
• in PRIMEDIC™ ChargerBasis / ChargerComfort (optional).
The integrated detection of charge endpoint detection protects the battery from harmful deep
discharge. If the battery charge is too low, both a visual and an acoustic signal are issued.
In case an AkuPak is stored outside the equipment, its charge status can be checked by
pressing button (2).
Fig. 23: PRIMEDIC™ AkuPak Battery charge indicator
(1) Battery charge indicator
(2) push button to activate battery charge indicator
Battery charge indicator (1) means:

81 % - 100 % charged

41 % - 60 % charged

1 % - 20 % charged
Note
Of the two charging possibilities mentioned above, PRIMEDIC™ AkuPak, will be
automatically recharged in case the charge should fall below 80 % of its charging
capacity.
This 80 %-limit can temporarily be made inoperative by pressing 3 seconds on push
button (2), i.e., the PRIMEDIC™AkuPak can be recharged even before reaching
this limit. This, for example, is practical if you wish to fully recharge
PRIMEDIC™AkuPak prior to next use, independent of its current charge status.
After recharging, the programmed 80 %-limit is operative for the next automatic full
recharge.